Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 931
53-1003098-01
13
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
bootp ignore
Parameters
bootp ignore
Example
rfs7000-37FABE(config-dhcp-policy-test)#bootp ignore
rfs7000-37FABE(config-dhcp-policy-test)#show context
dhcp-server-policy test
bootp ignore
rfs7000-37FABE(config-dhcp-policy-test)#
Related Commands:
dhcp-class
dhcp-server-policy
A DHCP user class applies different DHCP settings to a set of wireless clients. Wireless clients
using the same DHCP settings are grouped under one DHCP class. Grouping users into classes
facilitates the provision of differentiated service.
The following table summarizes DHCP class configuration commands.
dhcp-class
dhcp-class
Creates a DHCP server class and enters its configuration mode. Use this command to configure
user class option values. Once defined, the controller’s internal DHCP server uses the configured
values to group wireless clients into DHCP classes. Therefore, each user class consists of wireless
clients sharing the same set of user class values.
You can also use this command to modify an existing DHCP user class settings.
bootp ignore Enables controllers to ignore BOOTP requests
no Disables the ignore BOOTP requests option
Command Description Reference
dhcp-class Creates a DHCP class and enters its configuration mode page 931
dhcp-class-mode
commands
Invokes DHCP class configuration commands page 932