Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

930 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-dhcp-policy-test)#
dhcp-server-policy
Table 11 summarizes DHCP server policy configuration commands.
bootp
dhcp-server-policy
Configures a BOOTP specific configuration
Bootstrap Protocol (BOOTP) requests are used by UNIX diskless workstations to obtain the location
of their boot image and IP address within the managed network. A BOOTP configuration server
provides this information and also assigns an IP address from a configured pool of IP addresses. By
default, all BOOTP requests are forwarded to the BOOTP configuration server by the controller.
When enabled, this feature allows controllers, using this DHCP server policy, to ignore BOOTP
requests.
Supported in the following platforms:
TABLE 11 DHCP-Server-Policy-Config Commands
Command Description Reference
bootp Configures a BOOTP specific configuration page 930
dhcp-class Configures a DHCP server class page 931
dhcp-pool Configures a DHCP server address pool page 935
no Negates a command or sets its default page 973
option Defines the DHCP option used in DHCP pools page 975
ping Specifies ping parameters used by a DHCP server page 976
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425