Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 847
53-1003098-01
8
no authentication server <1-6>
{dscp|nac|nai-routing|proxy-mode|retry-timeout-factor|timeout}
no health-check interval
no mac-address-format
no proxy-attribute [nas-identifier|nas-ip-address]
no server-pooling-mode
no use nac-list
Example
The following example shows the AAA policy ‘test’ settings before the ‘no’
commands are executed:
rfs7000-37FABE(config-aaa-policy-test)#show context
aaa-policy test
authentication server 5 host 172.16.10.10 secret 0 example port 1009
authentication server 5 timeout 10
accounting server 2 host 172.16.10.10 secret 0 example port 1
accounting server 2 timeout 2 attempts 2
mac-address-format quad-dot case upper attributes username-password
authentication protocol chap
accounting interim interval 65
accounting server preference auth-server-number
health-check interval 4000
attribute framed-mtu 110
rfs7000-37FABE(config-aaa-policy-test)#
rfs7000-37FABE(config-aaa-policy-test)#no accounting server 2 timeout 2
rfs7000-37FABE(config-aaa-policy-test)#no accounting interim interval
rfs7000-37FABE(config-aaa-policy-test)#no health-check interval
rfs7000-37FABE(config-aaa-policy-test)#no attribute framed-mtu
rfs7000-37FABE(config-aaa-policy-test)#no authentication protocol
no authentication server
<1-6>
Resets the RADIUS authentication server’s (identified by its index number) settings
dscp Optional. Resets the DSCP value for RADIUS authentication
nac Optional. Disables NAC on the selected RADIUS authentication server
nai-routing Optional. Disables NAI forwarding requests
proxy-mode Optional. Resets proxy mode to the default of “no proxying”
retry-timeout-factor Optional. Resets retry timeout to its default of 100
timeout Optional. Resets all access parameters, such as timeout and retry attempts to their default
no health-check interval Resets all RADIUS servers’ health check interval to its default
no mac-address format Resets the MAC address format used in RADIUS request frames
no proxy-attribute
[nas-identifier|
nas-ip-address]
Resets RADIUS attribute behavior when proxying through a controller or RF Domain manager
no server-pooling-mode Resets the mode used to select a AAA server from a pool of configured servers
no use nac-list Detaches the current NAC list from this AAA policy