Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 823
53-1003098-01
7
override-wlan
Device Config Commands
Configures WLAN RF Domain level overrides
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
override-wlan Configures WLAN RF Domain level overrides
power-config Configures power mode features
preferred-controller-gro
up
Specifies the group the system prefers for adoption
preferred-tunnel-control
ler
Configures the tunnel preferred by the system for tunneling extended VLAN traffic
radius Configures device-level RADIUS authentication parameters
remove-override Removes device overrides
rf-domain-manager Enables the RF Domain manager
router Configures dynamic router protocol settings
rsa-key Assigns a RSA key to SSH
sensor-server Configures an AirDefense sensor server
spanning-tree Enables spanning tree commands
timezone Configures time zone settings
trustpoint Assigns a trustpoint to a service
tunnel-controller Configures the tunneled WLAN (extended VLAN) wireless controller or service platform’s name
use Defines the settings used by this feature
vrrp Configures VRRP group settings
wep-shared-key-auth Enables support for 802.11 WEP shared key authentication
clrscr Clears the display screen
commit Commits (saves) changes made in the current session
end Ends and exits the current mode and moves to the PRIV EXEC mode
exit Ends the current mode and moves to the previous mode
help Displays the interactive help system
revert Reverts changes to their last saved configuration
service Invokes service commands to troubleshoot or debug
(config-if) instance configurations
show Displays running system information
write Writes information to memory or terminal