Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

822 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
enforce-version Checks the device firmware version before attempting connection
environmental-sensor Configures the environmental sensor device settings. If the device is an environmental sensor, use this
command to configures its settings,
events Displays system event messages
export Enables export of startup.log file after every boot
floor Sets the building floor where the system is deployed
geo-coordinates Configures the geographic coordinates for this device
gre Enables GRE tunneling on this profile
hostname Sets a system's network name
http-analyze Enables HTTP analysis on this device
interface Selects an interface to configure
ip Configures IP components
l2tpv3 Defines the L2TP protocol for tunneling layer 2 payloads using VPNs
l3e-lite-table Configures L3e lite table aging time
layout-coordinates Configures layout coordinates
led Turns LEDs on or off
legacy-auto-downgrade Enables legacy device firmware to auto downgrade
legacy-auto-update Auto updates Brocade Mobility 650 Access Point and Brocade Mobility 71XX Access Point legacy device
firmware
lldp Configures LLDP settings for this profile
load-balancing Configures load balancing parameters
location Configures the location the system is deployed
logging Enables message logging
mac-address-table Configures the MAC address table
mac-auth Enables 802.1x authentication of hosts on this device
mac-name Configures MAC name to name mappings
memory-profile Configures device’s memory profile
meshpoint-device Configures device’s meshpoint parameters
meshpoint-monitor-inter
val
Configures meshpoint monitoring interval on the device
min-misconfiguration-re
covery-time
Configures the minimum connectivity verification time
mint Configures MiNT protocol commands
misconfiguration-recove
ry-time
Verifies connectivity after a device configuration is received
neighbor-inactivity-time
out
Configures a neighbor inactivity timeout
neighbor-info-interval Configures the neighbor information exchange interval
noc Configures NOC settings
ntp Configure the NTP server settings