Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 807
53-1003098-01
7
interface Selects an interface to configure page 7-653
ip Configures IP components page 7-744
l2tpv3 Defines the Layer 2 Tunnel Protocol (L2TP) protocol for tunneling Layer 2 payloads using
Virtual Private Networks (VPNs)
page 752
l3e-lite-table Configures L3e Lite Table with this profile page 753
layout-coordinates Configures layout coordinates page 7-815
led Turns LEDs on or off page 7-754
led-timeout Configures the LED-timeout timer in the device or profile configuration mode page 755
legacy-auto-downgrade Enables legacy device firmware to auto downgrade page 7-756
legacy-auto-update Auto updates Brocade Mobility 650 Access Point and Brocade Mobility 71XX Access
Point legacy device firmware
page 7-757
license Adds a license for a device’s features page 815
lldp Configures Link Layer Discovery Protocol (LLDP) settings for this profile page 7-757
load-balancing Configures load balancing parameters. page 7-759
location Configures the location the system is deployed page 7-817
logging Enables message logging page 7-763
mac-address-table Configures the MAC address table page 7-764
mac-auth Enables 802.1x authentication of hosts on this device page 766
mac-name Configures MAC name to name mappings page 7-818
memory-profile Configures memory profile used on the device page 769
meshpoint-device Configures meshpoint device parameters page 769
meshpoint-monitor-inte
rval
Configures meshpoint monitoring interval page 770
min-misconfiguration-re
covery-time
Configures the minimum device connectivity verification time page 771
mint Configures MiNT protocol commands page 7-772
misconfiguration-recov
ery-time
Verifies device connectivity after a configuration is received page 7-775
neighbor-inactivity-time
out
Configures a neighbor inactivity timeout page 7-776
neighbor-info-interval Configures the neighbor information exchange interval page 7-819
no Negates a command or resets values to their default settings page 820
noc Configures NOC settings page 7-780
ntp Configure the NTP server settings page 7-781
override-wlan Configures WLAN RF Domain level overrides page 7-823
power-config Configures power mode features page 7-783
preferred-controller-gro
up
Specifies the wireless controller or service platform group the system prefers for
adoption
page 7-784
Command Description Reference