Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

806 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
The following table summarizes device configuration mode commands.
Command Description Reference
adopter-auto-provisioni
ng-policy-lookup
Enables the use of a centralized auto provisioning policy on this device page 545
adoption-site Sets the device’s adoption site name page 808
alias Configures network, VLAN, and service aliases on a device page 546
area Sets the name of area where the system is deployed page 7-809
arp Configures ARP parameters page 7-552
auto-learn-staging-confi
g
Enables the automatic recognition of devices pending adoption page 7-553
autogen-uniqueid When executed in the device configuration mode, this command generates a unique ID
for the logged device.
page 554
autoinstall Autoinstalls firmware image and configuration setup parameters page 7-556
bridge Configures Ethernet Bridging parameters page 7-557
captive-portal Configures captive portal advanced Web page upload on this profile page 572
cdp Operates CDP on the device page 7-573
channel-list Configures channel list advertised to wireless clients page 7-810
cluster Sets cluster configuration page 7-574
configuration-persisten
ce
Enables configuration persistence across reloads page 7-576
contact Sets contact information page 7-810
controller Configures a WLAN’s wireless controller or service platform page 7-577
country-code Configures wireless controller or service platform’s country code page 7-811
critical-resource Monitors user configured IP addresses and logs their status page 580
crypto Configures data encryption protocols and settings page 7-583
device-upgrade Configures device firmware upgrade settings on this device page 631
dot1x Configures 802.1x standard authentication controls page 634
dscp-mapping Configures IP Differentiated Services Code Point (DSCP) to 802.1p priority mapping for
untagged frames
page 7-635
email-notification Configures e-mail notification page 7-636
enforce-version Checks the device firmware version before attempting connection page 7-638
environmental-sensor Configures the environmental sensor device settings. If the device is an environmental
sensor, use this command to configures its settings,
page 639
events Displays system event messages page 7-641
export Enables export of startup.log file after every boot page 642
floor Sets the building floor where the system is deployed page 7-812
geo-coordinates Configures the geographic coordinates for this device page 813
gre Enables GRE tunneling on this device page 644
hostname
Sets a system's network name page 7-814
http-analyze Enables HTTP analysis on this device page 652