Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

780 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
noc
Profile Config Commands
Configures Network Operations Center (NOC) settings, such as NOC statistics update interval
Supported in the following platforms:
meshpoint-device Configures the meshpoint device parameters
meshpoint-monitor-interval Configures the meshpoint monitoring interval
min-misconfiguration-recovery-ti
me
Configures the minimum connectivity (with connected device) verification time
mint Configures the MiNT protocol settings
misconfiguration-recovery-time Verifies connectivity after a device configuration file is received
neighbor-inactivity-timeout Configures neighbor inactivity timeout
neighbor-info-interval Configures the neighbor information exchange interval
noc Configures NOC settings
ntp Configures an NTP server
power-config Configures the power option mode. Sets the amount of power that the access point draws.
preferred-controller-group Specifies the wireless controller or service platform’s group preferred for adoption
preferred-tunnel-controller Configures the tunnel wireless controller or service platform’s name preferred for tunneling extended
VLAN traffic
radius Configures device-level RADIUS authentication parameters
rf-domain-manager Enables RF Domain manager
router Configures dynamic router protocol settings
spanning-tree Enables automatic AP firmware upgrade
tunnel-controller Configures the tunneled WLAN (extended-VLAN) wireless controller’s name
use Defines the settings used by this feature
vrrp Configures VRRP group settings
wep-shared-key-auth Enables support for 802.11 WEP shared key authentication
clrscr Clears the display screen
commit Commits (saves) changes made in the current session
end Ends and exits the current mode and moves to the PRIV EXEC mode
exit Ends the current mode and moves to the previous mode
help Displays the interactive help system
revert Reverts changes to their last saved configuration
service Invokes service commands to troubleshoot or debug (config-if) instance configurations
show Displays running system information
write Writes information to memory or terminal