Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

774 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
mint link ip <IP> {<1-65535>|adjacency-hold-time <2-600>|cost <1-10000>|
hello-interval <1-120>|level [1|2]|ipsec-security {gw}}
mint mlcp [ip|vlan]
mint spf-latency <0-60>
mint tunnel-controller-load-balancing level1
Example
rfs7000-37FABE(config-profile-default-rfs7000)#mint level 1 area-id 88
rfs7000-37FABE(config-profile-default-rfs7000)#mint link ip 1.2.3.4 level 1
rfs7000-37FABE(config-profile-default-rfs7000)#show context
cost <1-100000> This parameter is common to the ‘listen’ and ‘vlan’ parameters:
• Optional. Specifies the link cost in arbitrary units
• <1-100000> – Specify a value from 1 - 100000.
hello-interval <1-120> This parameter is common to the ‘listen’ and ‘vlan’ parameters:
• Optional. Specifies the interval between hello packets
• <1-120> – Specify a value from 1 - 120.
level [1|2] This parameter is common to the ‘listen’ and ‘vlan’ parameters:
Optional. Specifies the routing levels for this routing link. The options are:
• 1 – Configures local routing
• 2 – Configures inter-site routing
ipsec-security {gw} This parameter is common to the ‘listen’ and ‘vlan’ parameters:
• gw – Optional. Configures the IPSec security gateway
link ip <IP> Creates a MiNT routing link
• ip – Creates a MiNT tunnel over UDP/IP
• <IP> – Specify the IP address of the peer.
<1-65535> Select the peer UDP port from 1 - 65535.
adjacent-hold-time
<2-600>
Optional. Specifies the adjacency lifetime after hello packets cease
• <2-600> – Specify a value from 2 - 600 seconds.
cost <1-100000> Optional. Specifies the link cost in arbitrary units
• <1-100000> – Specify a value from 1 - 100000.
hello-interval <1-120> Optional. Specifies the hello interval between packets
<1-120> – Specify a value from 1 - 120.
level [1|2] Optional. Specifies the routing levels for this routing link. The options are:
• 1 – Configures local routing
• 2 – Configures inter-site routing
ipsec-security {gw} Optional. Configures the IPSec security gateway
mlcp [ip|vlan] Configures the MiNT Link Creation Protocol (MLCP)
• vlan – Configures MLCP over layer 2 (VLAN) links
• ip – Configures MLCP over layer 3 (UDP/IP) links
spf-latency <0-60> Specifies the latency of SPF routing recalculation
• <0-60> – Specify the latency from 0 - 60 seconds.
tunnel-controller-load-balanci
ng level1
Configures load balancing of MiNT extended VLAN traffic across tunnels
• level1 – Enables balancing of load of a tunnel wireless controller or service platform over VLAN links