Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 769
53-1003098-01
7
memory-profile
Profile Config Commands
Configures memory profile used on the device
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
memory-profile [adopted|standalone]
Parameters
memory-profile [adopted|standalone]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#memory-profile adopted
% Error on default-rfs7000: memory-profile is not supported on this device
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
meshpoint-device
Profile Config Commands
Configures meshpoint device parameters. This feature is configurable in the profile and device
configuration modes.
Supported in the following platforms:
• Access Points — Brocade Mobility 71XX Access Point
Syntax:
meshpoint-device <MESHPOINT-NAME>
Parameters
meshpoint-device <MESHPOINT-NAME>
adopted Configures adopted mode (no GUI and higher MiNT routes, firewall flows)
standalone Configures standalone mode (GUI and fewer MiNT routes, firewall flows)
no Resets device's memory profile configuration
meshpoint-device
<MESHPOINT-NAME>
Configures meshpoint device parameters
• <MESHPOINT-NAME> – Specify meshpoint name.