Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 765
53-1003098-01
7
Configures the MAC address table. Use this command to assign a static address to the MAC
address table.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
mac-address-table [aging-time|static]
mac-address-table aging-time [0|<10-1000000>]
mac-address-table static <MAC> vlan <1-4094> interface [<L2-INTERFACE>|ge
<1-4>|
port-channel <1-2>]
Parameters
mac-address-table aging-time [0|<10-1000000>]
mac-address-table static <MAC> vlan <1-4094> interface [<L2-INTERFACE>|ge
<1-4>|
port-channel <1-2>]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#mac-address-table static
00-40-96-B0-BA-2A vlan 1 interface ge 1
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
.........................................................
logging facility local4
mac-address-table static 00-40-96-B0-BA-2A vlan 1 interface ge1
ip nat pool pool1
--More--
aging-time
[0|<10-1000000>]
Sets the duration a learned MAC address persists after the last update
• 0 – Entering the value ‘0’ disables the aging time
• <10-1000000> – Sets the aging time from 10 -100000 seconds
static <MAC> Creates a static MAC address table entry
• <MAC> – Specifies the static address to add to the MAC address table. Specify the MAC address in
the AA-BB-CC-DD-EE-FF, AA:BB:CC:DD:EE:FF, or AABB.CCDD.EEFF format.
vlan <1-4094> Assigns a static MAC address to a specified VLAN port
• <1-4094> – Specify the VLAN index from 1 - 4094.
interface
[<L2-INTERFACE>|
ge <1-4>|
port-channel <1-2>]
Specifies the interface type. The options are: layer 2 Interface, GigabitEthernet interface, and a port
channel interface
• <L2-INTERFACE> – Specify the layer 2 interface name.
• ge – Specifies a GigabitEthernet interface
• <1-4> – Specify the GigabitEthernet interface index from 1 - 4.
• port-channel – Specifies a port channel interface
• <1-2> – Specify the port channel interface index from 1 - 2.