Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

738 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
apn TechPubs
auth-type mschap-v2
crypto map test
ip nat inside
ip default-gateway priority 1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Related Commands:
no
interface-config-wwan-instance
Removes or reverts the WWAN interface settings
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
no [all|apn|auth-type|crypto|description|ip|password|shutdown|use|username]
Parameters
None
Usage Guidelines:
The no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#no apn
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#no
auth-type
Related Commands:
password
interface-config-wwan-instance
no Removes IP related settings on this interface
apn Configures the access point’s name provided by the service provider
auth-type Configures the authentication types used on this interface
crypto Associates a crypto map with this interface
description Configures a unique description for this interface
ip Configures IP related settings on this interface
password Configures a password for this WWAN interface
use Associates an IP ACL with this interface
username Configures the names of users accessing this interface