Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 735
53-1003098-01
7
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
apn TechPubs
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Related Commands:
auth-type
interface-config-wwan-instance
Configures the authentication types used on this interface
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
auth-type [chap|mschap|mschap-v2|pap]
Parameters
auth-type [chap|mschap|mschap-v2|pap]
Example
rfs4000-229D58(config-profile-testBrocade Mobility
RFS4000-if-wwan1)#auth-type mschap-v2
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
apn TechPubs
auth-type mschap-v2
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Related Commands:
crypto
interface-config-wwan-instance
Associates a crypto map with this interface
no Removes the configured access point name.
auth-type Configures the authentication protocol used on this interface
chap Configures Challenge-Handshake Authentication Protocol (CHAP). This is the default value.
mschap Configures Microsoft Challenge-Handshake Authentication Protocol (MSCHAP)
mschapv2 Configures Microsoft Challenge-Handshake Authentication Protocol (MSCHAP) version 2
pap Configures Password Authentication Protocol (PAP)
no Removes the authentication protocol configured on this interface