Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

734 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs4000-229D58(config-profile-<PROFILE-NAME>-if-wwan1)#
NOTE
The WWAN interface is supported only on the Brocade Mobility 7131 Access Point, Brocade Mobility
RFS4000, Brocade Mobility RFS6000 platforms.
The following table summarizes WWAN interface configuration commands.
apn
interface-config-wwan-instance
Configures the access point’s name provided by the service provider. This setting is needed in
areas with multiple cellular data providers using the same protocols, such as Europe and Asia.
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
apn <WORD>
Parameters
apn <WORD>
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#apn
TechPubs
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Commands Description Reference
apn Configures the access point’s name provided by the service provider page 734
auth-type Configures the authentication types used on this interface page 735
crypto Associates a crypto map with this interface page 735
description Configures a unique description for this interface page 736
ip Associates an IP ACL with this interface page 737
no Removes or reverts the WWAN interface settings page 738
password Configures a password for this WWAN interface page 738
use Associates an IP ACL with this interface page 739
username Configures the names of users accessing this interface page 740
apn <WORD> Specify the service provided given access point name.