Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 725
53-1003098-01
7
Related Commands:
rifs
interface-config-radio-instance
Configures Reduced Interframe Spacing (RIFS) parameters on this radio
This value determines whether interframe spacing is applied to access point transmitted or
received packets, both, or none.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
rifs [none|rx-only|tx-only|tx-rx]
Parameters
rifs [none|rx-only|tx-only|tx-rx]
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#rifs tx-only
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
rf-mode sensor
placement outdoor
mesh client
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
rifs tx-only
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
non-unicast tx-rate bss 4 highest-basic
non-unicast tx-rate bss 5 highest-basic
non-unicast tx-rate bss 6 highest-basic
non-unicast tx-rate bss 7 highest-basic
non-unicast tx-rate bss 8 highest-basic
no Resets the radio’s RF mode of operation
data-rates Configures the 802.11 data rates on this radio
rifs Configures RIFS parameters
none Disables support for RIFS
Consider setting the value to None for high-priority traffic to reduce packet delay.
rx-only Supports RIFS possession only
tx-only Supports RIFS transmission only
tx-rx Supports both RIFS transmission and possession (default setting)