Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

718 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
power [<1-30>|smart]
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#power 12
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
power 12
data-rates b-only
placement outdoor
mesh client
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
non-unicast tx-rate bss 4 highest-basic
non-unicast tx-rate bss 5 highest-basic
non-unicast tx-rate bss 6 highest-basic
non-unicast tx-rate bss 7 highest-basic
non-unicast tx-rate bss 8 highest-basic
non-unicast tx-rate bss 9 highest-basic
non-unicast tx-rate bss 10 highest-basic
non-unicast tx-rate bss 11 highest-basic
non-unicast tx-rate bss 12 highest-basic
non-unicast tx-rate bss 13 highest-basic
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
preamble-short
interface-config-radio-instance
Enables short preamble on this radio. If using an 802.11bg radio, enable short preamble. Short
preambles improve throughput. However, some devices (SpectraLink phones) require long
preambles. This option is disabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
preamble-short
power Configures a radio’s transmit power
<1-30> Transmits power in dBm (actual power could be lower based on regulatory restrictions)
smart Smart RF determines the optimum transmit power needed
no Resets a radio’s transmit power