Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 689
53-1003098-01
7
aggregation ampdu max-aggr-size rx [8191|16383|32767|65535]
aggregation ampdu max-aggr-size tx <2000-65535>
aggregation ampdu min-spacing [0|1|2|4|8|16]
tx-only Supports the transmission of AMPDU aggregated frames only
rx-only Supports the receipt of AMPDU aggregated frames only
tx-rx Supports the transmission and receipt of AMPDU aggregated frames (default setting)
none Disables support for AMPDU aggregation
aggregation Configures 802.11n frame aggregation parameters
ampdu Configures AMPDU frame aggregation parameters
AMPDU aggregation collects Ethernet frames addressed to a single destination. It wraps each frame in an
802.11n MAC header. This aggregation mode is less efficient, but more reliable in environments with high
error rates. It enables the acknowledgement and retransmission of each aggregated data frame
individually.
max-aggr-size Configures AMPDU packet size limits. Configure the packet size limit on packets both transmitted and
received.
rx
[8191|16383|32767|
65535]
Configures the limit on received frames
• 8191 – Advertises a maximum of 8191 bytes
• 16383 – Advertises a maximum of 16383 bytes
• 32767 – Advertises a maximum of 32767 bytes
• 65535 – Advertises a maximum of 65535 bytes (default setting)
aggregation Configures 802.11n frame aggregation parameters
ampdu Configures AMPDU frame aggregation parameters
AMPDU aggregation collects Ethernet frames addressed to a single destination. It wraps each frame in an
802.11n MAC header. This aggregation mode is less efficient, but more reliable in environments with high
error rates. It enables the acknowledgement and retransmission of each aggregated data frame
individually.
max-aggr-size Configures AMPDU packet size limits. Configure the packet size limit on packets both transmitted and
received.
tx <2000-65535> Configures the maximum size (in bytes) for AMPDU aggregated transmitted frames
• <2000-65535> – Sets the limit from 2000 - 65535 bytes. The default is 65535 bytes.
aggregation Configures 802.11n frame aggregation parameters
ampdu Configures AMPDU frame aggregation parameters
AMPDU aggregation collects Ethernet frames addressed to a single destination. It wraps each frame in an
802.11n MAC header. This aggregation mode is less efficient, but more reliable in environments with high
error rates. It enables the acknowledgement and retransmission of each aggregated data frame
individually.
mn-spacing
[0|1|2|4|8|16]
Configures the minimum gap, in microseconds, between AMPDU frames
• 0 – Configures the minimum gap as 0 microseconds
• 1 – Configures the minimum gap as 1 microseconds
• 2 – Configures the minimum gap as 2 microseconds
• 4 – Configures the minimum gap as 4 microseconds (default setting)
• 8 – Configures the minimum gap as 8 microseconds
• 16 – Configures the minimum gap as 16 microseconds