Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual
686 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
radio-share-mode Configure the radio-share mode of operation for
this radio
rate-selection Default or Opportunistic rate selection
remove-override Negate a command or set its defaults
rf-mode Configure the rf-mode of operation for this radio
rifs Configure Reduced Interframe Spacing (RIFS)
parameters
rts-threshold Configure the RTS threshold
shutdown Shutdown the selected radio interface
sniffer-redirect Capture packets and redirect to an IP address
running a packet capture/analysis tool
stbc Configure Space-Time Block Coding (STBC) parameters
use Set setting to use
wireless-client Configure wireless client related parameters
wlan Enable wlans on this radio
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
The following table summarizes the radio interface configuration commands.
Commands Description Reference
aeroscout Enables Aeroscout multicast packet forwarding page 7-687
aggregation Configures 802.11n aggregation parameters page 688
airtime-fairness Enables fair access for clients based on airtime usage page 690
antenna-diversity Transmits antenna diversity for non-11n transmit rates page 691
antenna-downtilt Enables Advanced Element Panel Technology (ADEPT) antenna mode page 691
antenna-gain Specifies the antenna gain for the selected radio page 692
antenna-mode Configures the radio antenna mode page 693
beacon Configures beacon parameters page 694
channel Configures a radio’s channel of operation page 695
data-rates Specifies the 802.11 rates supported on a radio page 696
description Configures the selected radio’s description page 700
dfs-rehome Reverts to configured home channel once Dynamic Frequency Selection (DFS)
evacuation period expires
page 701
dynamic-chain-selecti
on
Enables automatic antenna mode selection page 702
ekahau Enables Ekahau multicast packet forwarding page 702
extended-range Configures extended range page 703
guard-interval Configures the 802.11n guard interval page 704










