Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

684 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Related Commands:
use
interface-config-vlan-instance
Specifies an IP access list to use with this VLAN interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use ip-access-list in <IP-ACCESS-LIST-NAME>
Parameters
use ip-access-list in <IP-ACCESS-LIST-NAME>
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#use ip-access-list in
test
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#show context
interface vlan8
ip address 10.0.0.1/8
use ip-access-list in test
ip helper-address 172.16.10.3
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
Related Commands:
interface-config-radio-instance
interface
This section documents radio interface configuration parameters applicable only to the access
point profiles and the RFS4011 profile.
no Disables or reverts interface VLAN settings to their default
ip-access-list in
<IP-ACCESS-LIST-NAME>
Uses a specified IP access list with this interface
• in – Sets incoming packets
• <IP-ACCESS-LIST-NAME> – Specify the IP access list name.
no Disables or reverts interface VLAN settings to their default