Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 657
53-1003098-01
7
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
The following table summarizes the interface configuration commands.
Command Description Reference
cdp Enables Cisco Discovery Protocol (CDP) on GE ports page 658
channel-group Configures channel group commands page 7-658
description Creates an interface specific description page 7-659
dot1x (authenticator) Configures 802.1X authenticator settings page 660
dot1x (supplicant) Configures 802.1X supplicant settings page 661
duplex Specifies the duplex mode for the interface page 7-662
ip Sets the IP address for the assigned Fast Ethernet interface (ME) and VLAN interface page 7-663
lldp Configures Link Local Discovery Protocol (LLDP) page 7-664
mac-auth Enables MAC-based port authentication on this profile page 665
no Negates a command or sets its defaults page 7-666
power Configures Power over Ethernet (PoE) settings on this interface page 667
qos Enables QoS page 7-668
shutdown Disables the selected interface page 7-668
spanning-tree Configures spanning tree parameters page 7-669
speed Specifies the speed of a FastEthernet or GigabitEthernet port page 7-671
switchport Sets interface switching mode characteristics page 7-672
use Defines the settings to use with this command page 7-674
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 5-394
service Invokes service commands to troubleshoot or debug (config-if) instance configurations page 394
show Displays running system information page 429
write Writes information to the memory or terminal page 425