Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

650 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#no
native vlan
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#no
tunneled-vlan
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#no
failover
The following example shows the GRE tunnel ‘testGRETunnel’ settings after the
no commands are executed:
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#show
context
gre tunnel testGRETunnel
peer 1 ip 192.168.13.6
native tagged
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#
Related Commands:
peer
gre-config-instance
Adds the GRE tunnel’s end-point peers. A maximum of two peers, representing the tunnel’s end
points, can be added for each GRE tunnel.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
peer <1-2> ip <IP>
Parameters
peer <1-2> ip <IP>
dscp Sets the GRE tunnel’s DSCP / 802.1q priority value
failover Enables periodic pinging of the primary gateway to assess its availability, in case it is unreachable
native Configures native trunking settings for this GRE tunnel
peer Configures the GRE tunnel’s end-point peers
tunneled-vlan Defines the VLAN that connected clients use to route GRE tunneled traffic within their respective WLANs
peer <1-2> ip <IP> Configures the tunnel’s end-point peers
• <1-2> – Specify a numeric index for each peer to help differentiate the tunnel end points.
• ip – Specifies the IP address of the added GRE peer to serve as a network address
identifier.
• <IP> – Specify the peer’s IP address.