Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

646 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Related Commands:
gre-config-instance
gre
The following table summarizes GRE tunnel configuration mode commands.
dscp
gre-config-instance
Sets the GRE tunnel’s DSCP / 802.1q priority value from encapsulated packets to the outer packet
IPv4 header.
This option is disabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
dscp [<0-63>|reflect]
Parameters
dscp [<0-63>|reflect]
Example
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#dscp
20
no Disables GRE tunneling on this profile
Command Description Reference
dscp Sets the GRE tunnel’s Differentiated Services Code Point (DSCP) / 802.1q priority value page 646
failover Enables periodic pinging of the primary gateway to assess its availability, in case it is
unreachable
page 647
native Configures native trunking settings for this GRE tunnel page 648
no Removes the GRE tunnel settings based on the parameters passed page 649
peer Configures the GRE tunnel’s end-point peers page 650
tunneled-vlan Defines the VLAN that connected clients use to route GRE-tunneled traffic within their
respective WLANs
page 651
dscp <0-63> Specifies the DSCP 802.1q priority value for outer packets from 0 - 63. The default is 1.
dscp reflect Copies the DSCP 802.1q value from inner packets