Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

572 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Related Commands:
use
bridge-vlan-mode commands
Uses pre configured access lists with this bridge policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use [ip-access-list|mac-access-list] tunnel out <IP/MAC-ACCESS-LIST-NAME>
Parameters
use [ip-access-list|mac-access-list] tunnel out <IP/MAC-ACCESS-LIST-NAME>
Example
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#use
mac-access-list tunnel out PERMIT-ARP-AND-IPv4
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#show context
bridge vlan 1
ip igmp snooping
ip igmp snooping querier
use mac-access-list tunnel out PERMIT-ARP-AND-IPv4
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
Related Commands:
captive-portal
Profile Config Commands
no Disables extended VLAN traffic over level 2 MiNT links
use Sets this VLAN bridge policy to use an IP access list or a MAC access list
ip-access-list tunnel Associates a pre-configured IP access list with this VLAN-bridge interface
mac-access-list Uses a pre-configured MAC access list with this VLAN- bridge interface
tunnel out
<IP/MAC-ACCESS-LIST-NAME>
The following keywords are common to the ‘IP access list’ and ‘MAC access list’ parameters:
• tunnel – Applies IP access list or MAC access list to all packets going into the tunnel
• out – Applies IP access list or MAC access list to all outgoing packets
• <IP/MAC-ACCESS-LIST-NAME> – Specify the IP access list or MAC access list name.
no Disables or reverts VLAN Ethernet bridge settings