Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 569
53-1003098-01
7
Example
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#no description
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#no ip igmp
snooping mrouter interface ge1
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#no ip igmp
snooping mrouter learn pim-dvmrp
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#no ip igmp
snooping querier max-response-time
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#no ip igmp
snooping querier version
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#show context
bridge vlan 1
no edge-vlan
no stateful-packet-inspection-l2
ip igmp snooping
no ip igmp snooping unknown-multicast-fwd
no ip igmp snooping mrouter learn pim-dvmrp
no ip igmp snooping querier
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
Related Commands:
stateful-packet-inspection-l2
bridge-vlan-mode commands
Enables a stateful packet inspection at the layer 2 firewall
bridging-mode Configures the VLAN’s bridging mode
description Configures the VLAN’s description
edge-vlan Enables the edge VLAN mode
ip Configures the VLAN’s IP components
l2-tunnel-broadcast-optimiz
ation
Enables broadcast optimization
stateful-packet-inspection-l
2
Enables stateful packet inspection in the layer 2 firewall
tunnel Enables tunneling of unicast messages to unknown MAC destinations, on the selected VLAN bridge
tunnel-over-level2 Enables extended VLAN traffic over level 2 MiNT links
use Uses pre configured access lists with this PF bridge policy
clrscr Clears the display screen
commit Commits (saves) changes made in the current session
end Ends and exits the current mode and moves to the PRIV EXEC mode
exit Ends the current mode and moves to the previous mode
help Displays interactive help system
revert Reverts changes to their last saved configuration
service Invokes service commands to troubleshoot or debug (config-if) instance configurations
show Displays running system information
write Writes information to memory or terminal