Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

566 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
ip igmp snooping querier max-response-time 24
ip igmp snooping querier timer expiry 100
ip igmp snooping mrouter interface ge2 ge1
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
Related Commands:
l2-tunnel-broadcast-optimization
bridge-vlan-mode commands
Enables broadcast optimization on this VLAN interface. Enabling this feature aids in the
identification of each incoming packet. This feature is disabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
l2-tunn2l-broadcast-optimization
Parameters
None
Example
rfs7000-37FABE(config-profile
default-rfs7000-bridge-vlan-1)#l2-tunnel-broadcast
-optimization
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#show context
bridge vlan 1
description This\ is\ a\ description\ for\ the\ bridged\ VLAN
l2-tunnel-broadcast-optimization
bridging-mode isolated-tunnel
ip arp trust
ip dhcp trust
ip igmp snooping
ip igmp snooping querier
ip igmp snooping mrouter interface ge2 ge1
ip igmp snooping querier version 2
ip igmp snooping querier max-response-time 24
ip igmp snooping querier timer expiry 100
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
Related Commands:
no Disables or reverts the VLAN Ethernet bridge parameters
no Disables broadcast optimization