Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 543
53-1003098-01
7
bridge Configures bridge specific parameters page 7-557
captive-portal configures captive portal advanced Web page upload on a device profile page 7-572
cdp Enables Cisco Discovery Protocol (CDP) on a device page 7-573
cluster Configures a cluster name page 7-574
configuration-persist
ence
Enables persistence of configuration across reloads page 7-576
controller Configures a wireless controller or service platform page 7-577
critical-resource Monitors user configured IP addresses and logs their status page 7-580
crypto Configures data encryption related protocols and settings page 7-583
device-upgrade Configures device firmware upgrade settings on this profile page 631
dot1x Configures 802.1x standard authentication controls page 634
dscp-mapping Configures an IP DSCP to 802.1p priority mapping for untagged frames page 7-635
email-notification Configures e-mail notification page 7-636
enforce-version Enables checking of a device’s firmware version before attempting adoption or clustering page 7-638
environmental-senso
r
Configures the environmental sensor settings on this profile page 639
events Displays system event messages page 7-641
export Enables export of startup.log file after every boot page 642
floor Sets the floor name where the system is located page 643
gre Enables Generic Routing Encapsulation (GRE) tunneling on this profile page 644
http-analyze Configures HTTP analysis settings page 652
interface Configures an interface (VLAN, radio, GE etc.) page 653
ip Configures IP components page 7-744
l2tpv3 Defines the Layer 2 Tunnel Protocol (L2TP) protocol for tunneling layer 2 payloads using
Virtual Private Networks (VPNs)
page 7-752
l3e-lite-table Configures L3e Lite Table with this profile page 7-753
led Turns device LEDs on or off page 7-754
led-timeout Configures LED-timeout timer. This command is specific to the NX9000 series service
platforms.
led-timeout
legacy-auto-downgra
de
Auto downgrades a legacy device firmware page 7-756
legacy-auto-update Auto upgrades a legacy device firmware page 7-757
lldp Configures
Link Layer Discovery Protocol (LLDP) page 7-757
load-balancing Configures load balancing parameters page 7-759
logging Modifies message logging page 7-763
mac-address-table Configures the MAC address table page 7-764
mac-auth Enables 802.1x user authentication protocol on this profile page 7-766
memory-profile Configures the memory profile used on the device page 769
TABLE 5 Profile-Config Commands
Command Description Reference