Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

542 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
vlan traffic
radius Configure device-level radius
authentication parameters
raid RAID
rf-domain-manager RF Domain Manager
router Dynamic routing
slot PCI expansion Slot
spanning-tree Spanning tree
tunnel-controller Tunnel Controller group this
controller belongs to
use Set setting to use
vrrp VRRP configuration
wep-shared-key-auth Enable support for 802.11 WEP
shared key authentication
clrscr Clears the display screen
commit Commit all changes made in this
session
do Run commands from Exec mode
end End current mode and change to EXEC
mode
exit End current mode and down to
previous mode
help Description of the interactive help
system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to
memory or terminal
<DEVICE>(config-profile-<PROFILE-NAME>)#
Profile Config Commands
PROFILES
Table 5 summarizes profile configuration commands.
TABLE 5 Profile-Config Commands
Command Description Reference
adopter-auto-provisio
ning-policy-lookup
Enables the use of a centralized auto provisioning policy on this profile page 545
alias Configures network, network-group, network-service, VLAN, and string aliases on this
profile
page 546
area Sets the system’s area of location (the area name) page 551
arp Configures static address resolution protocol page 7-552
auto-learn-staging-co
nfig
Enables network configuration learning of devices page 7-553
autogen-uniqueid Autogenerates a unique local ID for devices using this profile. When executed in the device
configuration mode, this command generates a unique ID for the logged device
page 554
autoinstall Configures the automatic install feature page 7-556