Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 427
53-1003098-01
Chapter
6
SHOW COMMANDS
Show commands display configuration settings or statistical information. Use this command to
view the current running configuration as well as the start-up configuration. The show command
also displays the current context’s configuration.
This chapter describes the ‘show’ CLI commands used in the USER EXEC, PRIV EXEC, and GLOBAL
CONFIG modes. Commands entered in either USER EXEC mode or PRIV EXEC mode are referred to
as EXEC mode commands. If a user or privilege is not specified, the referenced command can be
entered in either mode.
This chapter also describes the ‘show’ commands in the ‘GLOBAL CONFIG’ mode. The commands
can be entered in all three modes, except commands like file, IP access list statistics, MAC access
list statistics, and upgrade statistics, which cannot be entered in the USER EXEC mode.
show commands
Table 4 summarizes show commands.
TABLE 4 Show Commands
Command Description Reference
show Displays settings for the specified system component page 429
adoption Displays information related to adoption page 434
advanced-wips Displays advanced Wireless Intrusion Prevention System (WIPS) settings page 436
boot Displays a device boot configuration page 438
captive-portal Displays WLAN hotspot functions page 439
captive-portal-page-u
pload
Displays captive portal page related information page 443
cdp Displays a Cisco Discovery Protocol (CDP) neighbor table page 444
clock Displays the software system clock page 445
cluster Displays cluster commands page 446
commands Displays command list page 447
context Displays information about the current context page 448
critical-resources Displays critical resource information page 449
crypto Displays encryption mode information page 450
device-upgrade Displays device firmware upgradation information for devices adopted by a wireless
controller or access point
page 453
dot1x Displays dot1x information on interfaces page 454
environmental-sensor Displays environmental sensor’s historical data (applicable only to Brocade Mobility 1240
Access Point)
page 456