Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 425
53-1003098-01
5
session-changes Configuration changes made in this session
session-config This session configuration
sessions Display CLI sessions
site-config-diff Difference between site configuration on the NOC
and actual site configuration
smart-rf Smart-RF Management Commands
spanning-tree Display spanning tree information
startup-config Startup configuration
terminal Display terminal configuration parameters
timezone The timezone
upgrade-status Display last image upgrade status
version Display software & hardware version
vrrp VRRP protocol
what Perform global search
wireless Wireless commands
wwan Display wireless WAN Status
rfs7000-37FABE#
t
NOTE
For more information on the show command, see Chapter 6, SHOW COMMANDS.
write
Common Commands
Writes the system running configuration to memory or terminal
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
write [memory|terminal]
Parameters
write [memory|terminal]
Example
rfs7000-37FABE>write memory
[OK]
rfs7000-37FABE>
memory Writes to the non-volatile (NV) memory
terminal Writes to the terminal