Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 385
53-1003098-01
Chapter
5
COMMON COMMANDS
This chapter describes the CLI commands used in the USER EXEC, PRIV EXEC, and GLOBAL CONFIG
modes.
The PRIV EXEC command set contains commands available within the USER EXEC mode. Some
commands can be entered in either mode. Commands entered in either the USER EXEC or PRIV
EXEC mode are referred to as EXEC mode commands. If a user or privilege is not specified, the
referenced command can be entered in either mode.
Common Commands
Table 3 summarizes commands common to the User Exec, Priv Exec, and Global Config modes.
clrscr
Common Commands
Clears the screen and refreshes the prompt, irrespective of the mode
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
TABLE 3 Commands Common to Controller CLI Modes
Command Description Reference
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
exit Ends and exits the current mode and moves to the PRIV EXEC mode page 387
help Displays the interactive help system page 387
no Negates a command or reverts values to their default settings page 391
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394
show Displays running system information page 423
write Writes the system’s running configuration to memory or terminal page 425