Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

354 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
proxy-arp-mode strict
broadcast-dhcp validate-offer
shutdown on-unadoption
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
time-based-access
wlan-mode commands
Configures time-based client access to the network resources
Administrators can use this feature to assign fixed days and time of WLAN access for wireless
clients
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
time-based-access days [sunday|monday|tuesday|wednesday|thursday|friday|
saturday|all|weekends|weekdays] {start <START-TIME>} [end
<END-TIME>]
Parameters
time-based-access days [sunday|monday|tuesday|wednesday|thursday|friday|
saturday|all|weekends|weekdays] {start <START-TIME>} [end <END-TIME>]
day <option> Specifies the day or days on which the client can access the WLAN
• sunday – Allows access on Sundays only
• monday – Allows access on Mondays only
• Tuesday – Allows access on Tuesdays only
• wednesday – Allows access on Wednesdays only
• thursday – Allows access on Thursdays only
• friday – Allows access on Fridays only
• saturday – Allows access on Saturdays only
• weekends – Allows access on weekends only
• weekdays – Allows access on weekdays only
• all – Allows access on all days
start <START-TIME> Optional. Specifies the access start time in hours and minutes (HH:MM)
end <END-TIME> Specifies the access end time in hours and minutes (HH:MM)