Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 327
53-1003098-01
4
• Service Platforms — Brocade Mobility RFS9510
Syntax:
broadcast-dhcp validate-offer
Parameters
broadcast-dhcp validate-offer
Example
rfs7000-37FABE(config-wlan-test)#broadcast-dhcp validate-offer
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode local
encryption-type none
authentication-type eap
accounting syslog host 172.16.10.4 port 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
broadcast-dhcp validate-offer
rfs7000-37FABE(config-wlan-test)#
broadcast-ssid
wlan-mode commands
Advertises the WLAN SSID in beacons. This feature is enabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
broadcast-ssid
Parameters
None
Example
rfs7000-37FABE(config-wlan-1)#broadcast-ssid
rfs7000-37FABE(config-wlan-1)#
captive-portal-enforcement
wlan-mode commands
Configures the WLAN’s captive portal enforcement
validate-offer Validates the broadcast DHCP packet destination (a wireless client associated to the radio) before forwarding
over the air