Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

326 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
accounting syslog host 172.16.10.4 port 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
rfs7000-37FABE(config-wlan-test)#
bridging-mode
wlan-mode commands
Configures how packets are bridged to and from a WLAN
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
bridging-mode [local|tunnel]
Parameters
bridging-mode [local|tunnel]
Example
rfs7000-37FABE(config-wlan-test)#bridging-mode local
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode local
encryption-type none
authentication-type eap
accounting syslog host 172.16.10.4 port 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
rfs7000-37FABE(config-wlan-test)#
broadcast-dhcp
wlan-mode commands
Configures broadcast DHCP packet parameters
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
bridging-mode Configures how packets are bridged to and from a WLAN. The options are local and tunnel.
local Bridges packets between WLAN and local ethernet ports
tunnel Tunnels packets to other devices (typically a wireless controller or service platform). This is the default mode.