Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 315
53-1003098-01
4
br-detection Rogue AP detection
enable Enable this wips policy
event Configure an event
history-throttle-duration Configure the duration for which event duplicates
are not stored in history
interference-event Specify events which will contribute to smart-rf
wifi interference calculations
no Negate a command or set its defaults
signature Signature to configure
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-wips-policy-test)#
NOTE
For more information on WIPS policy commands, see Chapter 21, WIPS-POLICY.
Related Commands:
wlan
Global Configuration Commands
Configures a Wireless Local Area Network (WLAN)
The following table lists WLAN configuration mode commands.
wlan
wlan
Configures a WLAN and enters its configuration mode. Use this command to modify an existing
WLAN’s settings.
no Removes an existing WIPS policy
Command Description Reference
wlan Creates a new wireless LAN and enters its configuration mode page 315
wlan-mode
commands
Summarizes WLAN configuration mode commands page 318