Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

304 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
WIPS is not supported on a WLAN basis, rather sensor functionality is supported on the access
point radio(s) available to each controller managed WLAN. When an access point radio is
functioning as a WIPS sensor, it is able to scan in sensor mode across all legal channels within the
2.4 and 5.0 GHz bands. Sensor support requires a Brocade AirDefense WIPS Server on the
network. Sensor functionality is not provided by the access point alone. The access point works in
conjunction with a dedicated WIPS server
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
sensor-server <1-3> ip <IP> {port [443|8443|<1-65535>]}
Parameters
sensor-server <1-3> ip <IP> {port [443|8443|<1-65535>]}
Example
rfs7000-37FABE(config-rf-domain-default)#sensor-server 2 ip 172.16.10.3 port
443
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
contact Bob+919621212577
country-code in
sensor-server 2 ip 172.16.10.3
override-smartrf channel-list 2.4GHz 1,2,3
override-wlan test vlan-pool 2 limit 20
layout area Ecospace floor Floor5 map-location www.fiestfloor.com units
meters
rfs7000-37FABE(config-rf-domain-default)#
Related Commands:
stats
rf-domain-mode commands
Sensor-server <1-3> Configures an AirDefense sensor server parameters
• <1-3> – Select the server ID from 1 - 3. The server with the lowest defined ID is reached first. The default
is 1.
ip <IP> Configures the (non DNS) IP address of the sensor server
• <IP> – Specify the IP address of the sensor server.
port
[443|8443|
<1-65535>]
Optional. Configures the sensor server port. The options are:
• 443 – Configures port 443, the default port used by the AirDefense server
• 8843 – Configures port 883, the default port used by advanced WIPS
• <1-6553> – Allows you to select a WIPS/AirDefense sensor server port from 1 - 65535
no Disables an AirDefense sensor server parameters