Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

262 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
exclude 00-04-96-B0-BA-2A 00-04-96-B0-BA-2A precedence 1
include 00-15-70-38-06-49 00-15-70-38-06-49 precedence 2
rfs7000-37FABE(config-nac-list-test)#
no
nac-list-mode commands
Cancels an exclude or include NAC list rule
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [exclude|include]
no [exclude|include] <START-MAC> [<END-MAC> precedence <1-1000>|precedence
<1-1000>]
Parameters
no [exclude|include] <START-MAC> [<END-MAC> precedence <1-1000>|precedence
<1-1000>]
Example
The following example shows the NAC list ‘test’ settings before the ‘no’
command is executed:
rfs7000-37FABE(config-nac-list-test)#show context
nac-list test
exclude 00-04-96-B0-BA-2A 00-04-96-B0-BA-2A precedence 1
include 00-15-70-38-06-49 00-15-70-38-06-49 precedence 2
rfs7000-37FABE(config-nac-list-test)#
rfs7000-37FABE(config-nac-list-test)#no exclude 00-40-96-B0-BA-2A precedence 1
The following example shows the NAC list ‘test’ settings after the ‘no’
command is executed:
rfs7000-37FABE(config-nac-list-test)#show context
no exclude Removes an exclude rule
no include Removes an include rule
<START-MAC> Specifies a range of MACs included in/removed from the NAC enforcement list
Specify the first MAC address in the range.
NOTE: Use this parameter to specify a single MAC address.
<END-MAC> Specify the last MAC address in the range (optional if a single MAC is added to the list).
precedence <1-1000> Sets the rule precedence for this rule. Exclude entries are checked in the order of their rule precedence.
• <1-1000> – Specify a value from 1 - 1000.