Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 261
53-1003098-01
4
Parameters
exclude <START-MAC> [<END-MAC> precedence <1-1000>|precedence <1-1000>]
Example
rfs7000-37FABE(config-nac-list-test)#exclude 00-40-96-B0-BA-2A precedence 1
rfs7000-37FABE(config-nac-list-test)#show context
nac-list test
exclude 00-40-96-B0-BA-2A 00-40-96-B0-BA-2A precedence 1
rfs7000-37FABE(config-nac-list-test)#
include
nac-list-mode commands
Specifies the MAC addresses included in the NAC enforcement list
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
include <START-MAC> [<END-MAC> precedence <1-1000>|precedence <1-1000>]
Parameters
include <START-MAC> [<END-MAC> precedence <1-1000>|precedence <1-1000>]
Example
rfs7000-37FABE(config-nac-list-test)#include 00-15-70-38-06-49 precedence 2
rfs7000-37FABE(config-nac-list-test)#show context
nac-list test
<START-MAC> Specifies a range of MAC addresses or a single MAC address to exclude from the NAC enforcement list
• <START-MAC> – Specify the first MAC address in the range.
NOTE: Use this parameter to specify a single MAC address.
<END-MAC> Specifies the last MAC address in the range (optional if a single MAC is added to the list)
• <END-MAC> – Specify the last MAC address in the range.
precedence <1-1000> Sets the rule precedence. Exclude entries are checked in the order of their rule precedence.
• <1-1000> – Specify a value from 1 - 1000.
<START-MAC> Specifies a range of MAC addresses or a single MAC address to include in the NAC enforcement list
• <START-MAC> – Specify the first MAC address in the range.
NOTE: Use this parameter to specify a single MAC address
<END-MAC> Specifies the last MAC address in the range (optional if a single MAC is added to the list)
• <END-MAC> – Specify the last MAC address in the range.
precedence <1-1000> Sets the rule precedence. Exclude entries are checked in the order of their rule precedence.
• <1-1000> – Specify a value from 1 - 1000.