Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 243
53-1003098-01
4
nsm Configures Network Service Module (NSM) related event message
• dhcpc-err – Event DHCP certification error message
• dhcpdefrt – Event DHCP defrt message
• dhcpip – Event DHCP IP message
• dhcpipchg – Event DHCP IP change message
• dhcpipnoadd – Event DHCP IP overlaps static IP address message
• dhcplsexp – Event DHCP lease expiry message
• dhcpnak – Event DHCP server returned DHCP NAK response
• dhcpnodefrt – Event interface no default route message
• if-failback – Event interface failback message
• if-failover – EVENT Interface failover message
• ifdown – Event interface down message
• ifipcfg – Event interface IP config message
• ifup – Event interface up message
• nsm-ntp – Event translate host name message
pm Configures process monitor module related event messages
• procid – Event proc ID message
• procmaxrstrt – Event proc max restart message
• procnoresp – Event proc no response message
• procrstrt – Event proc restart message
• procstart – Event proc start message
• procstop – Event proc stop message
• procsysrstrt – Event proc system restart message
• startupcomplete – Event startup complete message
radconf Configures RADIUS configuration daemon related event messages
• could-not-stop-radius – Event could not stop RADIUS server message
• radiusdstart – Event RADIUS server started message
• radiusdstop – Event RADIUS server stopped message
radio Configures radio module related event messages
• acs-scan-complete – Event ACS scan completed
• acs-scan-started – Event ACS scan started
• channel-country-mismatch – Event channel and country of operation mismatch message
• radar-det-info – Detected radar info message
• radar-detected – Event radar detected message
• radar-scan-completed – Event radar scan completed message
• radar-scan-started – Event radar scan started message
• radio-antenna-error – Event invalid antenna type on this radio message
• radio-antenna-setting – Event antenna type setting on this radio message
• radio-state-change – Event radio state change message
• resume-home-channel – Event resume home channel message
smrt Configures SMART RF module related event messages
• calibration-done – Event calibration done message
• calibration-started – Event calibration started message
• channel-change – Event channel change message
• config-cleared – Configuration cleared event message
• cov-hole-recovery – Event coverage hole recovery message
• cov-hole-recovery-done – Event coverage hole recovery done message
• interference-recovery – Event interference recovery message
• neighbor-recovery – Event neighbor recovery message
• power-adjustment – Event power adjustment message
• root-recovery – Event meshpoint root recovery message
<event-type> <event-name>