Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual
240 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
diag Configures diagnostics module related event messages
• autogen-tech-sprt – Event autogen technical support message
• buf-usage – Event buffer usage message
• cpu-load – Event CPU load message
• cpu-usage-too-high – Event CPU usage high message
• cpu-usage-too-high-recovery – Event recovery from high CPU usage message
• disk-usage – Event disk usage message
• elapsed-time – Event elapsed time message
• fan-underspeed – Event fan underspeed message
• fd-count – Event forward count message
• free-flash-disk – Event free flash disk message
• free-flash-inodes – Event free flash inodes message
• free-nvram-disk – Event free nvram disk message
• free-nvram-inodes – Event free nvram inodes message
• free-ram – Event free ram message
• free-ram-disk – Event free ram disk message
• free-ram-inodes – Event free ram inodes message
• head-cache-usage – Event head cache usage message
• high-temp – Event high temp message
• ip-dest-usage – Event ip destination usage message
• led-identify – Event led identify message
• low-temp – Event low temp message
• mem-usage-too-high – Event memory usage high message
• mem-usage-too-high-recovery – Event recovery from high memory usage message
• new-led-state – Event new led state message
• over-temp – Event over temp message
• over-voltage – Event over voltage message
• poe-init-fail – Event PoE init fail message
• poe-power-level – Event PoE power level message
• poe-read-fail – Event PoE read fail message
• poe-state-change – Event PoE state change message
Contd..
• poe-state-change – Event PoE state change message
• pwrsply-fail – Event failure of power supply message
• raid-degraded – Event Redundant Array of Independent Disks (RAID) degraded message
• raid-error – Event RAID error message
• ram-usage – Event ram usage message
• under-voltage – Event under voltage message
• wd-reset-sys – Event wd reset system message
• wd-state-change – Event wd state change message
<event-type> <event-name>