Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 219
53-1003098-01
4
customize show-wireless-client-stats-rf
(average-retry-number,error-rate,noise,
q-index,rx-rate,signal,snr,t-index,tx-rate)
customize show-wireless-meshpoint (br-mac,cfg-as-root,hops,hostname <1-64>,
interface-ids,is-root,mesh-name <1-64>,mpid,next-hop-hostname
<1-64>,next-hop-ifid,
next-hop-use-time,path-metric,root-bound-time,root-hostname <1-64>,root-mpid)
rx-bytes Includes the rx-bytes column, which displays the total number of bytes received by the wireless client
rx-errors Includes the rx-error column, which displays the total number of errors received by the wireless client
rx-packets Includes the rx-packets column, which displays the total number of packets received by the wireless client
rx-throughput Includes the rx-throughput column, which displays the receive throughput at the wireless client
tx-bytes Includes the tx-bytes column, which displays the total number of bytes transmitted by the wireless client
tx-dropped Includes the tx-dropped column, which displays the total number of dropped packets by the wireless client
tx-packets Includes the tx-packets column, which displays the total number of packets transmitted by the wireless
client
tx-throughput Includes the tx-throughput column, which displays the transmission throughput at the wireless client
show-wireless-client-stats-r
f
Customizes the show wireless client stats RF command output
average-retry-number Includes the average-retry-number column, which displays the average number of retransmissions made per
packet
error-rate Includes the error-rate column, which displays the rate of error for the wireless client
hostname <1-64> Includes the hostname column, which displays the wireless client’s hostname
• <1-64> – Sets the hostname column width from 1 - 64 characters
mac Includes the MAC column, which displays the wireless client’s MAC address
noise Includes the noise column, which displays the noise (in dBm) as detected by the wireless client
q-index Includes the q-index column, which displays the RF quality index
NOTE: Higher values indicate better RF quality.
rx-rate Includes the rx-rate column, which displays the receive rate at the particular wireless client
signal Includes the signal column, which displays the signal strength (in dBm) at the particular wireless client
snr Includes the snr column, which displays the signal to noise (SNR) ratio (in dB) at the particular wireless
client
t-index Includes the t-index column, which displays the traffic utilization index at the particular wireless client
tx-rate Includes the tx-rate column, which displays the packet transmission rate at the particular wireless client
show-wireless-meshpoint Customizes the show wireless meshpoint command output
br-mac Includes the br-name column, which displays the AP’s MAC address in the AA-BB-CC-DD-EE-FF format.
Applicable only in case of non-controller meshpoints
cfg-as-root Includes the cfg-as-root column, which displays the configured root state of the meshpoint
hops Includes the hops column, which displays the number of hops to the root for this meshpoint
hostname <1-64> Includes the hostname column, which displays the AP’s hostname. Applicable only in case of
non-wireless controller meshpoints
• <1-64> – Sets the hostname column width from 1 - 64 characters
interface-ids Includes the interface-ids column, which displays the interface identifiers (interfaces used by this meshpoint)