Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 211
53-1003098-01
4
rfs4000-229D58(config-client-identity-group-test)#
client-identity-group-mode commands
client-identity-group
The following table summarizes a new client identity group configuration mode commands.
client-identity
client-identity-group-mode commands
Associates an existing and configured client identity (device fingerprinting) with this client identity
group
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
client-identity <CLIENT-IDENTITY-NAME> precedence <1-10000>
Parameters
client-identity <CLIENT-IDENTITY-NAME> precedence <1-10000>
Example
The following example shows two client identities created and configured:
rfs4000-229D58(config)#show context
!
! Configuration of Brocade Mobility RFS4000 version 5.5.0.0-018D
!
!
version 2.1
!
!
Command Description Reference
client-identity Associates an existing and configured client identity (device fingerprinting) with this client
identity group
page 211
no Removes the client identity associated with this client identity group page 208
client-identity
<CLIENT-IDENTITY-NAME>
Associates a client identity with this group
• <CLIENT-IDENTITY-NAME> – Specify a client identity name (should be existing and configured)
precedence <1-10000> Determines the order in which client identity is used.
<1-10000> – Specify this client identity precedence from <1-10000>.
The client identity rule is applied based on its precedence value. Lower the value, higher is the precedence.
Therefore, a client identity with precedence 5 will get precedence over a client identity having precedence
20.