Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 127
53-1003098-01
3
drwx Sat Jan 1 00:00:09 2000 startuplog
-rw- 176128 Fri Feb 15 14:32:51 2013 out.tar
rfs4000-229D58#
more
Privileged Exec Mode Commands
Displays files on the device’s file system. This command navigates and displays specific files in the
device’s file system. Provide the complete path to the file
more <file>.
The more command also displays the startup configuration file.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
more <FILE>
Parameters
more <FILE>
Example
rfs4000-229D58#more flash:/log/messages.log
Jan 01 00:04:12 2013: rfs4000-229D58 : %SYSTEM-3-LOGIN_FAIL: Log-in failed for
user 'admin' from 'ssh'
Jan 01 02:06:53 2013: rfs4000-229D58 : %SYSTEM-3-LOGIN_FAIL: Log-in failed for
user 'admin'superuser' from 'ssh'
Jan 01 02:07:01 2013: rfs4000-229D58 : %SYSTEM-3-LOGIN_FAIL: Log-in failed for
user 'admin'superuser' from 'ssh'
Jan 01 02:23:26 2013: rfs4000-229D58 : %NSM-4-IFDOWN: Interface ge1 is down
Jan 01 02:24:25 2013: rfs4000-229D58 : %NSM-4-IFUP: Interface ge1 is up
Jan 01 02:24:26 2013: rfs4000-229D58 : %NSM-4-IFUP: Interface ge1 is up
Jan 01 02:24:33 2013: rfs4000-229D58 : %NSM-4-IFDOWN: Interface ge1 is down
Jan 01 02:24:40 2013: rfs4000-229D58 : %NSM-4-IFUP: Interface ge1 is up
Jan 01 02:24:40 2013: rfs4000-229D58 : %NSM-4-IFUP: Interface ge1 is up
rfs4000-229D58#
no
Privileged Exec Mode Commands
Use the no command to revert a command or a set of parameters to their default. This command is
useful to turn off an enabled feature or to revert to default settings.
<FILE> Specify the file name and location.