Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1286 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
Example
rfs7000-37FABE(config-meshpoint-qos-test)#accelerated-multicast 224.0.0.1
classification video
rfs7000-37FABE(config-meshpoint-qos-test)#show context
meshpoint-qos-policy test
accelerated-multicast 224.0.0.1 classification video
rfs7000-37FABE(config-meshpoint-qos-test)#
Related Commands:
no
meshpoint-qos-policy-config-instance
Negates the commands for meshpoint QoS policy or resets their values to their default
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [accelerated-multicast|rate-limit]
no accelerated-multicast [<MULTICAST-IP>|autodetect]
rate-limit [meshpoint|neighbor] [from-air|to-air] {max-burst-size|rate}
no rate-limit [meshpoint|neighbor] [from-air|to-air] {red-threshold
[background|
best-effort|video|voice]}
Parameters
no accelerated-multicast [<MULTICAST-IP>|autodetect]
no rate-limit [meshpoint|neighbor] [from-air|to-air] {max-burst-size|rate}
no Resets accelerated multicast configurations for this meshpoint QoS policy
accelerated-multicast Resets the accelerated multicast stream address and forwarding QoS classification
<
MULTICAST-IP> Defines the IP address of the multicast stream to be reset
autodetect Lets the system automatically detect multicast streams to be reset
meshpoint Resets rate limit parameters for a meshpoint
neighbor Resets rate limit parameters for neighboring meshpoint devices
from-air Resets rate limit value for traffic from the wireless neighbor to the network.
to-air Resets the rate limit value for traffic from the network to the wireless neighbor.
max-burst-size Optional. Resets the maximum burst size in kilobytes
rate Optional. Configures the maximum traffic rate in kilobytes.