Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1284 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
Mesh QoS helps ensure each mesh point on the mesh network receives a fair share of the overall
bandwidth, either equally or as per the proportion configured. Packets directed towards clients are
classified into categories such as video, voice and data.packets within each category are
processed based on the weights defined for each mesh point.
To create a meshpoint, see meshpoint-config-instance. A meshpoint QoS policy is created from the
(config) instance. To create a meshpoint QoS policy use the following command:
<DEVICE>(config)#meshpoint-qos-policy <POLICYNAME>
rfs7000-37FABE(config)#meshpoint-qos-policy test
rfs7000-37FABE(config-meshpoint-qos-test)#
rfs7000-37FABE(config-meshpoint-qos-test)#?
Mesh Point QoS Mode commands:
accelerated-multicast Configure accelerated multicast streams address and
forwarding QoS classification
no Negate a command or set its defaults
rate-limit Configure traffic rate-limiting parameters on a
per-meshpoint/per-neighbor basis
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-meshpoint-qos-test)#
The following table summarizes the mespoint-qos-policy configuration commands.
Command Description Reference
accelerated-multicast Configures accelerated multicast parameters page 1285
no Negates a command or reverts settings to their default page 1286
rate-limit Configures the rate limits for this QoS policy page 1287
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if) instance
configurations
page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425