Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1279
53-1003098-01
27
allowed-vlans 1,10-16,18-23
neighbor inactivity-timeout 300
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode none
root
rfs7000-37FABE(config-meshpoint-test)#
Related Commands:
security-mode
meshpoint-config-instance
Configures the security mode for this meshpoint
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
security-mode [none|psk]
Parameters
security-mode [none|psk]
Example
rfs7000-37FABE(config-meshpoint-test)#security-mode psk
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
beacon-format mesh-point
control-vlan 1
allowed-vlans 1,10-16,18-23
neighbor inactivity-timeout 300
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode psk
root
rfs7000-37FABE(config-meshpoint-test)#
no Removes the configuration of this meshpoint as a root meshpoint
security-mode Configures the security mode for this meshpoint
none No security is configured for this meshpoint
psk Uses Pre Shared Key (PSK) as the security mode. When using this option, use the wpa2 command to
enter a 64 character HEX or an 8-63 ASCII character passphrase used for authentication on the mesh
point.