Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1275
53-1003098-01
27
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
neighbor inactivity-timeout <60-86400>
Parameters
neighbor inactivity-timeout <60-86400>
Example
rfs7000-37FABE(config-meshpoint-test)#neighbor inactivity-timeout 300
rfs7000-37FABE(config-meshpoint-test)#show context
meshpoint test
description "This is an example of a meshpoint description"
meshid TestingMeshPoint
beacon-format mesh-point
control-vlan 1
allowed-vlans 1,10-16,18-23
neighbor inactivity-timeout 300
data-rates 2.4GHz bgn
data-rates 5GHz an
security-mode none
no root
rfs7000-37FABE(config-meshpoint-test)#
Related Commands:
no
meshpoint-config-instance
Negates meshpoint commands or resets their values to default
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
neighbor inactivity-timeout
<60-86400>
Configures the neighbor inactivity timeout in seconds. This represents the allowed interval between
frames received from a neighbor before their client privileges are revoked.
• <60-86400> – Specify a value from 60 - 86400 seconds. The default is 120 seconds.
no Removes the configured neighbor inactivity time out value for this meshpoint