Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1261
53-1003098-01
26
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
authorization [access-method|allow-privileged-commands|server]
authorization access-method [all|console|telnet|ssh] {(console|ssh|telnet)}
authorization server [<1-2>|preference]
authorization server <1-2> [host|retry-timeout-factor|timeout]
authorizationserver <1-2> host <IP/HOSTNAME> {secret [0 <SECRET>|2
<SECRET>|<SECRET>]}
{port <1-65535>}
authorization server <1-2> retry-timeout-factor <50-200>
authorization server <1-2> timeout <3-5> {attempts <1-3>}
authorization server preference
[authenticated-server-host|authenticated-server-
number|none]
Parameters
authorization access-method [all|console|telnet|ssh] {(console|ssh|telnet)}
authorization allow-privileged-commands
authorization server <1-2> host <IP/HOSTNAME> {secret [0 <SECRET>|2
<SECRET>|<SECRET>]} {port <1-65535>}
access-method Configures the access method for command authorization
all Authorizes commands from all access methods
console Authorizes commands from the console only
telnet Authorizes commands from Telnet only
ssh Authorizes commands from SSH only
{console|ssh|telnet} Optional. Configures more than one access method for command authorization.
allow-privileged-commands Allows privileged commands execution without command authorization. This option is disabled by
default.
server <1-2> Configures a TACACS authorization server. Up to 2 TACACS servers can be configured
• <1-2> – Specify the TACACS server index from 1 - 2.
host <IP/HOSTNAME> Sets the TACACS server’s IP address or hostname