Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 1247
53-1003098-01
25
Parameters
default-next-hop [<IP>|<ROUTER-IF-NAME>|pppoe1|vlan <1-4094>|wwan1]
Example
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#default-next-hop
wwan1
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#show context
route-map 1
default-next-hop wwan1
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#
Related Commands:
fallback
route-map-mode
Enables fallback to destination-based routing. This option is enabled by default. To disable fallback,
use the no > fallback command.
The action taken for packets satisfying the match criteria is determined by the mark (action)
clauses. If no action is defined, the default is to fallback to destination-based routing.
NOTE
If no mark clause is configured and fallback to destination-based routing is disabled, then the packet
is dropped.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
fallback
Parameters
None
default-next-hop Sets the next hop router to which packets are sent in case the next hop is not the adjacent router
<IP> Specifies next hop router’s IP address
<ROUTER-IF-NAME> Specifies the outgoing interface name (router interface name)
pppoe1 Specifies the PPPoE interface
vlan <1-4094> Specifies a VLAN interface ID from 1 - 4094
wwan1 Specifies the WAN interface
no Removes default next hop router settings