Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual
1246 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
25
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#
Related Commands:
route-map-mode
routing-policy-commands
The following table summarizes route-map configuration commands.
default-next-hop
route-map-mode
Sets the default next hop for packets satisfying match criteria
If a packet, subjected to PBR, does not have an explicit route to the destination, the configured
default next hop is used. This value is set as either the IP address of the next hop or the outgoing
interface. Only one default next hop can be defined. The difference between the next hop and the
default next-hop is: in case of the former, PBR occurs first, then destination-based routing. In case
of the latter, the order is reverse. Use this command to set either the default next hop IP address or
define either a WWAN1, PPPoE1, or VLAN interface.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
default-next-hop [<IP>|<ROUTER-IF-NAME>|pppoe1|vlan <1-4094>|wwan1]
no Removes a route map
Command Description Reference
default-next-hop Sets the default next hop for packets satisfying match criteria page 1246
fallback Configures a fallback to the next destination page 1247
mark Marks action clause for packets satisfying match criteria page 1248
match Sets match clauses for the route map page 25-1248
next-hop Sets the next hop for packets satisfying match criteria page 1250
no Negates a command or sets its default page 1251