Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

1240 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
24
Example
The following example shows the OSPF router interface settings before the ‘no’
commands are executed:
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
network 1.2.3.0/24 area 4.5.6.7
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
redistribute static metric-type 1
passive vlan1
route-limit num-routes 10 reset-time 10
ip default-gateway priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#no area 4
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#no auto-cost
reference-bandwidth
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#no network
1.2.3.0/24 area 4.5.6.7
The following example shows the OSPF router interface settings after the ‘no’
commands are executed:
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
default-information originate metric 1 metric-type 2
redistribute static metric-type 1
passive vlan1
route-limit num-routes 10 reset-time 10
ip default-gateway priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
area Configures OSPF network areas (OSPF enables interfaces)
auto-cost Configures the reference bandwidth in terms of megabits per second
default-information Controls the distribution of default route information
ip Configures IP default gateway priority
network Assigns networks to specified areas
ospf Enables OSPF
passive Configures a specified OSPF interface as passive
redistribute Specifies the route types redistributed by OSPF
route-limit Limits the number of routes managed by OSPF
router-id Specifies the router ID for OSPF
vrrp-state-check Publishes interface via OSPF based on VRRP status